Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Fort Collins?
Chimney liner installation in Fort Collins typically costs $2,400 to $5,800, and a firebox or crown rebuild usually runs $900 to $3,200 depending on how much masonry has to come out. A straightforward stainless reline for a single-story ranch home often lands near the lower end, while a full-height rebuild on an older masonry chimney pushes toward the top. We give you a written estimate before any work begins, so the number you see is the number you pay.
Key Takeaways
- Stainless liner installs in Fort Collins generally fall between $2,400 and $5,800.
- Firebox resurfacing with HeatShield costs far less than rebuilding the firebox with new brick.
- Crown and cap repairs are the cheapest line items and the most common cause of water damage.
- Older masonry chimneys near Old Town often need more prep work than newer construction.
- Estimates are free, and the written quote sets the final price. Call (833) 740-1407.
Chimney Liner & Rebuild Cost Breakdown (2026)
Every chimney is different, but these are the ranges we see most often for Fort Collins homes going into the 2026 season. We specify materials by name because what goes inside your chimney matters as much as the labor, and that shows up in the line items below.
| Line item | Typical cost range | What it covers |
|---|---|---|
| Stainless liner (single-story, standard flue) | $2,400 – $3,900 | DuraFlex flexible stainless liner, insulation, top plate, and cap |
| Stainless liner (two-story or offset flue) | $3,600 – $5,800 | Longer run, offset routing, and additional fittings |
| Firebox resurfacing (HeatShield) | $900 – $1,800 | Resurfacing system applied to cracked or spalled firebox walls |
| Firebox rebuild (new brick and mortar) | $2,200 – $3,200 | Full tear-out and rebuild of the firebox |
| Crown repair or rebuild | $350 – $1,100 | Sealing cracks or replacing the crown to shed water |
| Chimney cap and top-sealing damper | $180 – $650 | Stops rain, animals, and downdrafts |
| Masonry repointing (limited area) | $500 – $1,400 | Grinding out and replacing failed mortar joints |
| Full chimney rebuild (above roofline) | $4,500 – $9,000 | Tear-down and rebuild of the chimney stack where structure has failed |
What pushes a job up or down comes down to a few things. A straight flue with no offsets is cheaper than one that bends around a furnace connection. A chimney that’s already been lined with clay tile may only need a stainless sleeve inside it, which takes less labor than a from-scratch install. If the firebox is cracked but structurally sound, HeatShield firebox restoration instead of a quick patch or a full rebuild saves real money. And if water has been getting in through a failed crown for years, the masonry behind it may need repointing before we can even talk about the liner. We’ll tell you exactly what we found and exactly what it costs to fix it, before any work begins.
What Affects Chimney Liner & Rebuild Pricing in Fort Collins
- Home age and construction type. Fort Collins has a lot of older masonry chimneys in the neighborhoods around Old Town, and those often carry clay tile liners that have cracked or shifted over the decades. Restoring or relining an older chimney takes more prep than a newer home with a factory-built flue, which moves the price up.
- Flue length and shape. A single-story ranch home with a straight run is the cheaper scenario. A two-story house or a flue with an offset around a furnace or water heater connection requires more liner, more fittings, and more time on the roof.
- Masonry condition. Spalling brick, crumbling mortar, or a crown that’s cracked and letting water in all add work. Addressing the masonry first protects the new liner, so it’s part of the same job.
- What the inspection finds. We inspect before we quote a liner or rebuild because the scope depends on what’s actually in the flue. A camera inspection shows cracks, gaps, and blockages you can’t see from the firebox. That’s why the estimate is written after we’ve looked, not before.
- Materials and brand. Liner grade matters. We install DuraFlex flexible stainless systems for relining jobs that need a flexible solution, and we use established brands like Olympia Chimney, Gelco, Famco, and Copperfield for components. Cut-rate operators often use thinner, unlisted products that won’t hold up to a wood fire season.
- Fort Collins winters. Freeze-thaw cycles along the Front Range are hard on masonry. Water gets into small cracks, freezes, expands, and opens them wider. That’s why a good crown and cap are part of most chimney jobs here and why deferring crown repair tends to raise the eventual rebuild cost.
How to Save on Chimney Liner & Rebuild
The best way to keep chimney costs down is to catch problems before they turn into rebuilds. A cracked crown is a few hundred dollars to fix. A crown that’s let water in for several winters can mean repointing, rebuilding, and a liner all at once. If your chimney hasn’t been inspected in a while, a standalone inspection is the cheapest way to know where you stand. We offer inspection as its own service, which is useful for home buyers, sellers, and insurance documentation.
A few practical ways to keep the total lower:
- Get the inspection first. Knowing what’s actually wrong prevents paying for work you don’t need and catches what does need fixing before it spreads.
- Combine the sweep and inspection. If you’re booking a sweep anyway, adding the inspection to the same visit saves the hassle of two appointments and gives you one clear scope to price against.
- Fix the crown and cap early. These are the cheapest line items on any chimney and the ones that most often prevent the expensive work. A top-sealing damper and a proper cap keep rain, snow, and animals out.
- Resurface the firebox before it needs a rebuild. HeatShield firebox restoration handles cracked firebox walls before they fail completely. Rebuilding with new brick costs significantly more than resurfacing in good time.
- Get a written estimate before you commit. A clear scope with brand names on it lets you compare bids fairly. Ours is free, and we’ll walk you through every line.
Call (833) 740-1407 for a free estimate. We answer 24/7, fast dispatch from 7am to 7pm, Sunday through Friday. One call covers the sweep, the inspection, and the repair, no handoffs, no surprises.
Why Fort Collins Homeowners Choose a Chimney Specialist
A chimney specialist, not a generalist with a brush, matters when the job moves past cleaning into liner and rebuild work. Liner installation, firebox resurfacing, and masonry repair take specific tools, materials, and know-how. A handyman who also does gutters and decks isn’t set up for a stainless reline or a firebox rebuild, and the results usually show it a few seasons later. We focus only on chimneys, sweep, inspection, and repair, which keeps our technicians sharp on the work that matters here.
Our technicians have up to experience, and they’ve seen the full range of what Front Collins chimneys do over time. We work with six professional-grade brands: DuraFlex for flexible stainless relining, HeatShield for firebox restoration, plus Gelco, Olympia Chimney, Famco, and Copperfield for the components that go onto and around the flue. Most general contractors and even some chimney companies don’t carry HeatShield or know how to apply it. We do, and that means a firebox that could have needed a full rebuild can often be resurfaced instead.
Being full-service under one roof means the company that finds the problem is the same one that fixes it. When we schedule a chimney sweep Fort Collins visit and the inspection turns up a cracked liner, we can quote the DuraFlex reline on the spot and schedule it. No second company, no re-explaining the problem, no delay.
What a Typical Liner or Rebuild Job Involves
When we come out for a reline, the visit usually breaks into stages. We start with a camera inspection of the flue to confirm the liner size we need and spot any gaps or spalling in the masonry. Then we prep the flue, remove any old failed liner material, and make sure the pathway is clear. We install the DuraFlex stainless liner with insulation rated for the appliance it serves, top it with a plate and cap, and test the draft. For a firebox, we clean and prep the firebox walls, apply HeatShield, and let it cure to spec before any fire is lit. A rebuild follows the same logic but with tear-out and new masonry. Each stage has a line item on the estimate, so you know what you’re paying for.
Safety matters here. A failed liner or cracked firebox can let heat and gases into the wall cavity, and that’s not something to handle with a patch kit from the hardware store. Liner work happens on the roof, and firebox and flue work happens with high heat in a confined space. We recommend a trained technician for anything beyond the visible firebox surface. If a technician says the flue needs a liner, that’s a job for someone who does it every week, not a weekend project.
What to Check Before You Light the First Fire
You can check a few things yourself. Look inside the firebox for cracks in the brick or gaps in the mortar joints. Look up the flue with a flashlight and see if you can spot daylight coming through cracks in the masonry, which means the flue isn’t sealed. Check the crown at the top of the chimney for cracks, and make sure the cap is intact and the damper opens and closes smoothly. If anything looks off, stop and call us. The best time to catch a liner problem is before the first fire of the season, when it’s a repair instead of a rebuild.
Chimney Liner & Rebuild Pricing Around Fort Collins
Pricing shifts a little depending on the neighborhood and the era of construction. Homes near Old Town and the streets around City Park are often older masonry chimneys, which sometimes need more prep and masonry work. Newer homes out toward the edges of town more often have factory-built fireplaces that can still need relining but don’t usually need structural rebuilds. Book an inspection on the Fort Collins site and we’ll scope the work properly.
Wherever you are in the area, the estimate process is the same. We look, we quote, and the written estimate sets the final price. We don’t do phone quotes for liner or rebuild work because we can’t see your chimney over the phone, and we won’t guess at a number that ends up changing on the day.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner cost in Fort Collins?
A stainless liner install in Fort Collins typically costs $2,400 to $5,800, with most single-story homes landing between $2,400 and $3,900. A two-story or offset flue pushes toward the top of the range because of the extra liner, fittings, and roof time. Call (833) 740-1407 for an exact quote, estimates are free.
Is it cheaper to repair or replace a chimney liner?
Repairing a liner usually means relining, and relining is almost always cheaper than rebuilding the chimney around a failed liner. If the clay tile is cracked or shifted, a stainless sleeve like DuraFlex runs $2,400 to $5,800 versus $4,500 to $9,000 for a full above-roofline rebuild. The rebuild only becomes necessary when the masonry itself has failed, not just the liner. Call (833) 740-1407 and we’ll tell you which category you’re in.
How much does a firebox rebuild cost in Fort Collins?
A full firebox rebuild runs $2,200 to $3,200, but a HeatShield resurfacing typically costs $900 to $1,800 and handles many cracked or spalled fireboxes without tearing out the brick. We’ll tell you which option fits once we see the firebox. Call (833) 740-1407 for a free estimate.
Can you come today?
Same-day service is often possible depending on the schedule. We answer 24/7 and dispatch crews 7am to 7pm, Sunday through Friday. For a liner or rebuild quote, we’ll book the inspection and estimate, and we’ll tell you exactly what we found and exactly what it costs to fix it before any work begins. Call (833) 740-1407.
Why does a chimney rebuild cost so much more than a liner?
A rebuild involves tear-out of failed masonry, new brick and mortar laid up above the roofline, flashing, and finishing, all of which takes more labor and material than installing a liner inside an existing flue. Rebuilds run $4,500 to $9,000 while liners run $2,400 to $5,800. Keeping the crown and cap in good shape is the cheapest way to avoid the rebuild category. Call (833) 740-1407 for a free estimate on either.
When you’re ready to know what your chimney actually needs, one call covers the sweep, the inspection, and the repair. Call (833) 740-1407 for a free estimate. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday. The written estimate sets the final price, and we won’t start work until you’ve approved it.
Pricing reflects the Fort Collins market as of 2026. Chimney Sweep Fort Collins offers free estimates – call (833) 740-1407.
Written by the team at Chimney Sweep Fort Collins.
What Our Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Sarah Novak"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Eric Lawson"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Shane Quinn